beautypg.com

Set stop bits, Serial interface control lines, Òserial interface control – Nortel Networks CTA 500dm User Manual

Page 56: And if &d is either 1, 2 or 3 (see the, Òserial interface control linesó, For the commands), For more details), And if &d is either 1, 2 or 3 (see, Òserial interface control linesó on, Immediately before the indication if &c is 1 (see

background image

56 AT commands

CTA 500

dm On Line Guide

P0873832 Issue 05

Set Stop Bits

The Set Stop Bits Command

&P6=value

sets the number of stop bits on the interface between the CTA 500dm
and the attached computer. The following table shows the supported
values.

Result Codes

OK Appears when the value is supported.

ERROR Appears when the selected value is not recognized or is not
supported.

Serial Interface Control Lines

Change the operation of the control lines on the serial interface by
using AT commands.

Value

Use

0

one stop bit (default)

1

one and one-half stop bits

2

two stop bits

See also other documents in the category Nortel Networks Hardware: