Nortel Networks CTA 500dm - Manual (Page 38)

38 AT commands
CTA 500 dm On Line Guide P0873832 Issue 05
View Parameters
The View Parameters Command
&V[value]
instructs the CTA 500dm to return stored values.
The returned strings vary according to the value included in the
command. (See the possible values in the following table.) If no
value is speciÞed, the default value of 0 is used.
Parameters are displayed in alphabetical order using a maximum
width of 72 columns.
Result Codes
OK Appears following display of the requested parameters.
ERROR Appears when the chosen value was invalid.
Set Local Echo
The Set Local Echo Command
E[value]
instructs the CTA 500dm to turn the local AT command echo on or
off. A value of 0 turns the echo off and a value of 1 turns the echo
on. No value defaults to a value of 1.
Result Codes
OK Appears when the command was successful.
ERROR Appears when the chosen value was invalid.
Value Returned strings
0 all stored profiles
1 all stored dial strings
4 all stored Caller ID Security numbers