Nortel Networks CTA 500dm - Manual (Page 41)

AT commands 41
P0873832 Issue 05 CTA 500 dm On Line Guide
Call Monitoring Result Code Selection
The Call Monitoring Result Code Selection Command
X[value]
controls the format of result codes sent by the CTA 500dm in
verbose mode during call setup. (See possible values in the
following table.) Values 1 and 2 are identical since the CTA 500dm
does not support dial tone detection.
Result Codes
OK Appears when the value is acceptable.
ERROR Appears when the value is unacceptable.
S-registers
The S-registers allow you to control CTA 500dm operation. The
registers are usually both read and write accessible. The registers
used vary with the application supported by the CTA 500dm. All
S-registers are saved as part of a CTA 500dm proÞle. S-registers can
appear as a group by using the &V command (see
ÒGeneralÓ on
page 35 for more information).
S-register commands summary
Value Result Code Operation
0 connect result code, no busy detection
1 connect rate result code, no busy detection
2 connect rate result code, no busy detection
3 connect rate result code, busy detection
4 connect rate result code, busy detection (default)
Command Description Value
Sn= set value to S-register depends on register
Sn? query S-register value