Nortel Networks CTA 500dm - Manual (Page 4)

4 CTA 500dm
CTA 500 dm On Line Guide P0873832 Issue 05
CTA 500 dm feature summary
¥ digital networking using PPP/MP
¥ simpliÞed installation and conÞguration using installation wizard
¥ high-speed network rate (56, 64, 112, or 128 kbit/s)
¥ high-speed serial port support (maximum 115,200 baud)
¥ integrated desktop solutions (Norstar set, data transfer, and CTI)
¥ bonding of two 56/64 kbit/s channels using MP
¥ dynamic bandwidth allocation between voice and data sessions
¥ data transfer using 3.1 kHz audio call type in ISDN
¥ support of Password Authentication Protocol (PAP) and with
PPP connections, Challenge Handshake Authentication Protocol
(CHAP)
¥ Hayes AT command dialing and conÞguration
¥ incoming call screening using calling line identiÞcation for
security
¥ in-Þeld software upgrade for feature enhancement
¥ ICS call management feature support (for example, dialing
restrictions, station message detail recording)
¥ ICS default conÞguration for simpliÞed installation
About this document
¥ The First-time setup section has initial installation information.
¥ The Installation and setup section has information on installing
the CTA 500 dm and conÞguring your PC and ICS.
¥ The ConÞguration section has information on conÞguring the
CTA 500 dm and Norstar TAPI Service Provider.
¥ The Installing Norstar TAPI SP section has information on
setting up Norstar TAPI Service Provider
¥ The Resource sharing section shows how to conÞgure PCs
equipped with CTA 500 dm to act as Dial-Up Servers.
¥ The AT commands section details the commands used to
conÞgure the CTA 500 dm .
¥ The Troubleshooting section assists you if you experience
problems when using the CTA 500 dm .
¥ The Appendix provides important electromagnetic and radio
frequency information.