Nortel Networks CTA 500dm - Manual (Page 50)

50 AT commands
CTA 500 dm On Line Guide P0873832 Issue 05
Speech Bearer Call Answer Control
The Speech Bearer Call Answer Control Command
%A93=value
allows the CTA 500dm to accept or reject incoming calls received
over the speech bearer service.
The following table shows the values for speech bearer service calls
control.
Result Codes
OK Sent if the selected value is understood.
ERROR Sent if the selected value is not recognized or is not
supported.
Audio Bearer Call Answer Control
The Audio Bearer Call Answer Control Command
%A94=value
allows the CTA 500dm to accept or reject incoming calls received
over the 3.1 kHz audio bearer service.
The following table shows the values for 3.1 kHz audio bearer
service calls control.
Result Codes
OK Appears when the selected value is understood.
ERROR Appears when the selected value is not recognized or is not
supported.
Value Speech Bearer Service Calls
0 rejected (default)
1 accepted
Value 3.1 kHz Audio Bearer Service Calls
0 rejected (default)
1 accepted