Monitor – Nx Networks NX series User Manual
Page 50
50(86)
Control keypad
7
=
Start button.
Pressing this button starts the motor if the keypad is the active control
place. See Chapter 7.3.3.1.
=
Stop button.
Pressing this button stops the motor (unless disabled by parameter
R3.4/R3.6).
7.3 Navigation on the control keypad
The data on the control keypad are arranged in menus and submenus. The menus are used for
example for the display and editing of measurement and control signals, parameter settings
(chapter 7.3.2), reference values and fault displays (chapter 7.3.4). Through the menus, the
contrast of the display (page 73) can be adjusted.
The first menu level consists of menus M1 to M7 and is called the Main menu. The user can
navigate in the main menu using the
Browser buttons
up and down. The desired submenu can be
entered from the main menu using the
Menu buttons
. When there still are pages to enter under
the currently displayed menu or page, an arrow ( ) can be seen in the lower right corner of the
display and by pressing the
right arrow menu button
, the next menu level can be reached.
The control keypad navigation chart is shown on the next page. Please note that the menu M1 is
located in the lower left corner. From there it is possible to navigate your way up to the desired
menu using the menu and browser buttons.
More detailed descriptions of the menus can be found later in this Chapter.
start
stop
Monitor
V1
"
V14
STOP
READY
Local
Location
Description
Number of items
available; Item value