Nx Networks NX series - Manual (Page 17)

Technical data 17(86)
4
4.3 Technical data
Table 4-2. Technical data (continues on next page)
Input voltage U
in
Input frequency
Connection to mains
Output voltage
Starting torque
Output frequency
Frequency resolution
Control method
Switching frequency
(See parameter 2.6.9)
Frequency reference
Analogue input
Panel reference
Field weakening point
Acceleration time
Deceleration time
Braking torque
Ambient operating
temperature
Storage temperature
Air quality:
- chemical vapours
- mechanical particles
5...200 Hz
Displacement amplitude 3 mm at 5...10.7 Hz
Max acceleration amplitude 0.7 G at 10.7...200 Hz
Shock
EN50178, IEC 68-2-27
UPS Drop Test (for applicable UPS weights)
Storage and shipping: max 15 G, 11 ms (in package)
Ambient
conditions
IEC 721-3-3, unit in operation, class 3C2
IEC 721-3-3, unit in operation, class 3S2
Altitude 100% load capacity (no derating) up to 1000m
1-% derating for each 100m above 1000m; max. 3000m
IP21/NEMA1 standard in entire kW/HP range
IP54/NEMA12 option in entire kW/HP range
Note! Keypad installation required for IP54 Enclosure class
–40ºC...+70ºC
Relative humidity 0 to 95% RH, non-condensing, non-corrosive,
no dripping water
Vibration
(IEC 721-3-3, EN50178/
EN60068-2-6, IEC68-2-6
(68-2-34, -35, -36)
208...240 V; 380...500 V; 525...690 V; -15%...+10%
45...66 Hz
Once per minute or less (normal case)
0—U
in
30...320 Hz
0...3000 sec
0...3000 sec
Motor
connection
I
H
: Ambient temperature max. +50ºC,
overload 1.5 x I
H
(1min/10min)
I
L
: Ambient temperature max. +40ºC,
overload 1.1 x I
L
(1min/10min)
150% (Low overload); 200% (High overload)
0...320 Hz (NXS); 7200 Hz (Special)
0.01 Hz (NXS); Application dependent (NXP)
Starting current
Mains
connection
Continuous output current
DC-brake: 30%*T
N
(without brake option)
–10ºC (no frost)... +50ºC: I
H
–10ºC (no frost)... +40ºC: I
L
2.5 x I
H
2 secs every 20 secs, if output frequency <30Hz
and temperature of heatsink <+60ºC (up to 400 kW)
Frequency Control U/f
Open Loop Sensorless Vector Control
Closed Loop Frequency Control
Closed Loop Vector Control (NXP only)
Up to and including NX 0061:
1...16 kHz; Factory default 10 kHz
From NX 0072:
1...10 kHz; Factory default 3.6 kHz
Control
characteristrics
Resolution 0.1% (10bit), accuracy ±1%
Resolution 0.01 Hz