NComputing L300 - Manual (Page 38)

L300/L230/L130 User Manual
38
The "Information" tab shows the following information about the selected session:

The "Station name" field shows the access device's name that was defined via the vSpace admin
console.

The "Logged in user" field shows the username that is currently logged in.

The "Default user" field shows the default username for the vSpace user session. If one is not
configured, it shows the last user that logged in.

The "Status" field shows the session connection status.

The "Client connection" field shows the UTMA session and the IP address of the access device used.

The "Display Id" field shows the
access device’s display ID.

The "Hardware Id" field shows the access device’s virtual hardware ID.

The "Keyboard Id" field shows what type of keyboard interface is used.

The "Pointer Id" field shows what type of pointer interface is used.
In the to
olbar, there are three buttons: “Send Message,” “View Station” and “Stop Station.
Note: The “View Station” button may not be present if this function is disabled. The “View Station” button is not
present when you select the session that you are currently using.
To send a message to a session, select the session and click on the “Send Message” button in the toolbar.
The “Broadcast” tab allows you to select an access device to send the message to, a “From” entry, and a
message. The access device must be conne
cted to the same host PC. The “Network Broadcast” tab allows
you to send a message to an access device that is connected to the same host PC or a different host PC on
the same network.
To view a session’s screen, select the session and click on the “View Station” button. When viewing a
session’s screen, you may select whether or not to control the mouse and keyboard remotely and whether or
not to allow the user to control the mouse and keyboard. To see and change these settings, right-click on the
title bar
of the session view to bring up a menu. There are two settings, “Controlled by TS Admin” and “User
Input Allowed.”
To stop a session, select the session and click on the “Stop Station” button