Nortel Networks VT100 - Manual (Page 51)

3-12 Getting started
555-9001-316 Standard 1.0 February 1996
Baud Rate
300 to 19200. Setting the baud rate tells the TRS the rate at which it is to
communicate with the host. Set the baud rate by typing B then the rate. For
example B4800 or B19200.
Parity
PARENB enables parity generation and detection.
PAREVN sets parity to even.
PARODD sets parity to odd.
CSTOPB
CSTOPB select 1 stop bit per character. If CSTOPB is not specified, then
there are 2 stop bits per character.
DIAL_UP
Enter DIAL_UP in the com.conf file if IVR 2.0/I is going to access the host
computer via modem.
DEBUG_LEVEL
1 to 5. Setting the debug level determines how much debugging information
is sent to the /u/ivr/vt100/vt100log file.
MAXIMUM_WAIT_TIME
This parameter tells the TRS how long to wait for the output from the host to
end. Only use this parameter if you can not use a screen.conf file. The wait
time is specified in seconds.