Paxar Monarch 9413 - Manual (Page 41)

Image Buffer Used to image the current format. You can
create an image up to 16 inches long by
reallocating memory. The Image Buffer is
cleared after a printer reset, even if it is
stored in non-volatile RAM.
Use the formula below to calculate the
required image buffer size.
22K x Length
Length is the length of your label in inches.
Example 22K x 6 = 132K (Multiply by 10.)
132K x 10 = 1320
Enter 1320 for your Image buffer.
Format Buffer Used to store formats and batch data. Use
the following formula to calculate the required
format buffer size:
Linecount x 50/1024
Linecount is the number of lines in your
format packet including the format header
and all the options.
The result of the above calculation is in
kilobytes.
Downloadable
Fonts Buffer Used to store downloaded soft (bitmapped)
fonts. To determine the size of your
downloadable fonts, send a font packet. See
"Using the Font Packet" for more information.
Scalable (Vector)
Fonts Buffer Used to image the scalable font characters.
Increasing this buffer size allows more
characters to be saved in cache memory, so
the characters do not have to be re-built the
next time they are printed. Scalable fonts are
not available for these printers, use 0.
Configuring the Printer 3-19