Philips DTR7510/05 - Manual (Page 5)

5 Important
EN
G
LI
SH
Your receiver is powered using an AC power cord. The Digital Terrestrial Receiver has been
manufactured to meet the appropriate safety standards, but the instructions below must be followed
to operate it safely. These instructions must be kept for future reference.
Danger
• The Digital Terrestrial Receiver does not contain any user-serviceable parts. Do not attempt to
open them. All maintenance work must be carried out by qualified services centres.
• The supplied mains plug may be a non-rewireable type or a rewireable type. Both types contain
an approved 3A fuse. If you need to replace the fuse, use an ASTA- or BSI-approved BS 1362 fuse,
rated at 3A and marked with either of these symbols.
• Non-rewireable plugs have the fuse beneath a fuse cover on the plug face. Use a screwdriver to
lever off the fuse cover, replace the fuse with a new one and refit its cover. Never use a plug if its
fuse cover is missing.
• Rewireable plugs have the fuse inside. Use a screwdriver to remove the plug’s back cover, then
lever out the fuse and replace it with a new one. Replace the plug’s back cover. If the supplied
mains plug is not suitable for your mains socket-outlet, remove its fuse and then cut the plug off
the lead. Destroy the severed plug immediately to avoid the shock hazard which would exist if this
were to be plugged into a mains socket. Do not attempt to repair or modify the mains lead or
plug. Fit an appropriate mains plug on the lead. If this plug contains a fuse, it should be as described
above. If you are using a non-fused plug, an external fuse must not exceed 5A.
• Make sure that children do not place any foreign objects in any of the openings.
Warnings
• Before connecting the AC power cord to the mains, check that the mains supply voltage
corresponds to the voltage printed on it. If the mains voltage is different, consult your dealer.
• The AC power cord has been designed for indoor use only.
• It is recommended to unplug the AC power cord from the mains during lightning storms.
• Periodically inspect the AC power cord for damage. Do not use if damage is found. Always refer to
qualified services centres.
• To prevent fire or shock hazard, do not expose the Digital Terrestrial Receiver to rain or moisture.
• The Digital Terrestrial Receiver should be placed on a firm surface, and the ventilation openings
must not be covered with items, such as newspapers, table clothes, curtains, etc.
• Do not install the Digital Terrestrial Receiver near heat sources such as radiators, stoves or other
apparatus that produce heat. Protect it from direct sunlight.
• When installing the Digital Terrestrial Receiver, ensure there is a gap of approximately 5 cm
around the Digital Terrestrial Receiver to enable air to circulate freely and prevent overheating.
• Leave accessible the AC power cord in case emergency shutdown is required.
• Do not place any combustible objects on the Digital Terrestrial Receiver (candles, etc.).
• No objects filled with liquids, such as vases, shall be placed on the unit. The Digital Terrestrial
Receiver shall not be exposed to dripping or splashing. Should this happen, disconnect the AC
power cord from the mains and consult qualified services centres.
• Do not move the product or turn the power off suddently while the hard disk drive is running.
The company shall not be liable for any corruption of data on the hard disk drive caused by the
carelessness or misuse of users.
Refer also to the cautions throughout this manual.
DTR 7510 200910.indd 5 16/10/2009 17:40:44