Philips DTR7510/05 - Manual (Page 42)

Accessories and connections 42
Choose one brand code, made up of 4 digits,
from the code list at the end of this manual.
(If several codes are possible, go through this
procedure with the first code and try your
remote control. If you are not successful,
repeat the procedure with the second code,
and so on).
Press the SELECT key repeatedly to
choose the mode corresponding to the type
of device you want to set up (TV, VCR, DVD
or Amp/Tuner).
Simultaneously press digits 1 and 3 until the
indicator surrounding the key blinks twice
then release these keys.
Enter the 4 digit code corresponding to the
device brand you have chosen.The indicator
surrounding the key blinks once after each
one of the first three entries.The indicator
surrounding the key blinks twice after the
fourth entry.
If an invalid code has been entered, the indicator
surrounding the key blinks once only. Restart
from step 1.
Notes
• If the battery change takes more than 1
minute the remote control may return to
the Philips default settings.Therefore you
have to proceed with a new setting of your
remote control with the help of the table
above for your non-Philips branded devices.
• All manufacturers are concerned about
the constant improvement of their
products.Although your remote control is
compatible with most of the equipment of
the following list, Philips cannot guarantee
its operation with the complete range of
products on the market
To do so:
Press SELECT repeatedly to select the STB
mode.
Simultaneously press keys 1 and 3 until the
STB indicator turns on then release the keys.
Enter code 993.The indicator surrounding
the key blinks once after each digit entry.
Press the VOL-/+ key.The indicator
surrounding the key blinks twice.
You have made several setting changes and you
want to restore the default volume control
assignment settings
(see table in next paragraph)
Default volume control assignment means:
• in TV mode, volume control is performed
through a Philips brand TV set
• in VCR mode, volume control is performed
through a Philips brand TV set
• in DVD mode, volume control is
performed through a Philips brand TV set
• in AMP mode, volume control is performed
through a Philips brand amplifier only.
To restore default settings:
Simultaneously press keys 1 and 3 until the
indicator surrounding the key blinks twice
then release these keys.
Enter code 981.The indicator surrounding
the key blinks twice.
7.3.3 Changing the brand setting of your
remote control for your TV, VCR,
DVD or Amplifier
By default at first power up or at first
installation, your universal remote control is pre-
set to control your Digital Receiver as well
as most Philips brand audio/video devices.
If you have other brands of devices, or if the
presets do not enable you to control your
Philips device, please follow the procedure
below.
DTR 7510 200910.indd 42 16/10/2009 17:41:08