Philips DTR7510/05 - Manual (Page 41)

41 Accessories and connections
EN
G
LI
SH
7.3 Universal remote control
Prior to using your universal remote control,
check or set the following:
• Device you want to control (Mode
selection)
• Volume and mute control assignment
• Brand setting for your TV, VCR, DVD and
Amplifier
7.3.1 Mode selection (selecting the
device you want to control)
Your 5-in-1 remote control can be used to
control most of your audio/video equipment
through various modes:
• STB mode for the control of your Digital
Receiver
• TV mode for the control of your TV set
• VCR mode for the control of your VCR
• DVD mode for the control of your DVD
or DVD Recorder
• AMP mode for the control of your audio
tuner/amplifier.
Press SELECT once to check which mode
is active.To change the mode, press SELECT
repeatedly until the desired mode is signalled by
the corresponding indicator.
The mode sequence is:
STB --> TV --> VCR --> DVD --> AMP.
7.3.2 Volume and mute control
assignment
Default volume and mute control
assignment
For each mode, you can select the device of
your audio/video set-up to which volume and
mute control is assigned.
When in STB mode, the volume functions
(VOL+/- and keys) can be controlled
through your TV set, amplifier, or digital receiver.
By default, volume control is performed through
a Philips brand TV set.
When in TV, VCR or DVD mode, the volume
functions (VOL+/- and keys) can be
controlled through your TV set or amplifier. By
default, volume control is performed through a
Philips brand TV set.
When in AMP mode, the volume functions
(VOL+/- and keys) can be controlled
through a Philips brand amplifier only.
Changing the volume and mute control
assignment
The procedures below assume you start from
default settings.
Your Digital Receiver (STB), TV, VCR or DVD
audio outputs are “all” connected to your
amplifier. We advise you to assign volume control
to your amplifier for all modes (STB, TV, VCR,
and DVD).
To do so:
Press SELECT repeatedly to select the
AMP mode.
Simultaneously press keys 1 and 3 until the
AMP indicator turns on then release these
keys.
Enter code 993.The indicator surrounding
the key blinks once after each entry.
Press the VOL-/+ key.The indicator
surrounding the key blinks twice.
From then on, whatever mode you are in, the
AMP indicator turns on each time you press one
of the (VOL+/- and keys).
When controlling the volume, make sure the
source selector of your amplifier is properly set
(refer to your amplifier user manual for source
selection).
Note
If your TV set is only fitted with SCART
connectors (no HDMI, no DVI and no YPbPr),
we advise you to assign volume control to your
digital receiver for the STB mode.
DTR 7510 200910.indd 41 16/10/2009 17:41:08