Using the cli – Paradyne IP DSLAM GranDSLAM 4200 User Manual
Page 46
4. Configuration
4-2
January 2004
4200-A2-GN20-40
Using the CLI
The GranDSLAM 4200 uses Transaction Language 1 (TL1) language for CLI
commands and messages. These commands and messages are used to
configure and maintain the system. See the
for detailed information about the CLI.
TL1 offers the following features to help you with command entry:
Automatic command completion. You need to type only enough of a
command to make it unique, then type a question mark (?) and the CLI then
completes the command.
For example, if you enter:
RTRV-H
the CLI expands it to:
RTRV-HDR:[TID]::[CTAG];
Automatic completion of optional fields. Pressing the Tab key while
entering a command causes the CLI to fill in the optional fields.
For example, enter:
RTRV-HDR
Press the Tab key, the CLI fills in the TID:
RTRV-HDR:TL1-Agent
Press the Tab key twice again, the CLI fills in the delimiters:
RTRV-HDR:TL1-Agent::
Press the Tab key again, the CLI fills in the CTAG:
RTRV-HDR:TL1-Agent::100
Keep pressing the Tab key to fill in the rest of the command delimiters:
RTRV-HDR:TL1-Agent::100::;
Command listing. If you begin typing a command, then press the Tab key, the
CLI cycles through all the commands that contain the characters you have just
typed.
For example, enter:
RTRV-PROFILE
Press the Tab key, the CLI displays:
RTRV-PROFILE-ADSLALM
Press the Tab key again, the CLI displays:
RTRV-PROFILE-ADSLDNALM
Press the Tab key again, the CLI displays:
RTRV-PROFILE-ADSLDN