Paradyne IP DSLAM GranDSLAM 4200 - Manual (Page 23)

1. Installation
4200-A2-GN20-40 January 2004 1-13
Installing the Uplink Module
Each GranDSLAM 4200 requires an uplink module for connection to the ATM
network. If your uplink module was shipped separately from the
GranDSLAM 4200, install the uplink module before you connect the unit to a
power source. If your GranDSLAM 4200 arrived with an uplink module already
installed, proceed to
Chapter 2, Cabling .
NOTE:
The uplink modules are hot swappable. If you install an uplink module after the
unit has already been powered-on, reset the unit before attempting to operate
it.
HANDLING PRECAUTIONS FOR
STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from damage
due to electrostatic discharge (ESD) during normal operation. When
performing installation procedures, however, take proper static control
precautions to prevent damage to equipment. If you are not sure of the
proper static control precautions, contact your nearest sales or service
representative.
Procedure
To install the uplink module:
1. Remove the two captive screws holding the blank filler panel on the
GranDSLAM 4200.
2. Store the blank filler panel and screws for possible future use.
!
02-17264
1
12
13
24
4 8
16 20
POWER
A
ALARM
RTN -48V DC
BITS
MGMT
CONSOLE
ST A TUS
UPLINK
ALRM TEST
B
A
3.5 A 60
B