Paradyne IP DSLAM GranDSLAM 4200 - Manual (Page 13)

1. Installation
4200-A2-GN20-40 January 2004 1-3
Cables Required
Table 1-2 shows all the cables that may be required for your installation.
Table 1-2. Cable Descriptions
Connector Name Connector and Cable For Connecting . . .
DSL PORTS 1–24
POTS 1–24
50-pin RJ21X Telco-type
straight connector and 50-wire
cable. Two cables required, one
for DSL and one for POTS (if
used). Up to 24 DSL ports to Main
Distribution Frame, punchdown
block, or splitters.
Up to 24 POTS splitter ports to
Main Distribution Frame or
punchdown block.
4201 T1 MODULE:
100 Ω RJ48C
A downstream
GranDSLAM 4200 to an
upstream ATM network.
4202 E1 MODULE:
„ TX/RX 75 Ω
„ 120 Ω
„ BNC
„ RJ48C
A downstream
GranDSLAM 4200 to an
upstream ATM network.
4203 T1/E1 IMA
MODULE RJ48C „ A downstream
GranDSLAM 4200 to an
upstream ATM network.
„ A GranDSLAM 4200
aggregation unit to a basic
unit in a stack.
MGMT 8-position modular plug and
8-wire Category 5 or better
unshielded twisted pair (UTP)
cable. The GranDSLAM 4200 to a
Network Management System
over a Local Area Network (LAN)
employing 10BaseT or
100BaseT.
CONSOLE DB9 plug connector and
shielded cable.
„ The other connector
depends on the serial port on
your terminal or PC, but
normally is a DB9 socket.
„ The other connector
depends on the serial port on
your modem, but normally is
a DB25 plug.
The GranDSLAM 4200 to one of
the following:
„ A terminal or a PC with a
terminal emulation program,
or
„ A modem.
4210 ALARM 3-position terminal block and
3-wire shielded, twisted-pair
cable. The GranDSLAM 4200 to an
alarm system.
4220/4230 ALARM 5-position terminal block and
5-wire shielded, twisted pair
cable. The GranDSLAM 4200 to an
alarm system.
BITS (Building
Integrated Timing
Supply) Not applicable. For future use.