Pitney Bowes ADDRESSRIGHTTM DA900 - Manual (Page 43)

DA900 AddressRight ™ Printer
5
5-7 SV60970-OG Rev. A
5 - Adjust Printer
The media thickness knob located on the front control panel
(see below) sets the distance between the printheads and the
material. This distance must vary according to the thickness
of the material fed.
To adjust for media thickness:
1. Determine the correct thickness setting by printing a test
piece with the knob in the middle position.
Turn the knob clockwise for thicker material, counterclock-
wise for thinner material.
Media Thickness Dial Setting
0.004 to 1/32" 0 to 2
1/32 to 1/8" 2 to 3
1/8 to 1/4" 3 to 7
1/4 to 3/8" 7 to 10
4. Adjust for
Media
Thickness
2. If the address on the test piece appears blurred or too
light, lower the printhead (turn knob counterclockwise). If
the address appears smeared, turn knob clockwise in
small increments and continue testing until the printing is
clear.
Media Thickness Knob