Pitney Bowes ADDRESSRIGHTTM DA900 - Manual (Page 38)

5
Printer Adjustments
5-2 SV60970-OG Rev. A
1. Set the
Separator
Gap
About this
Chapter To print a job, you must set up the printer for the job and
make print selections from the software.
This chapter explains how to:
• Adjust the printer to accommodate the width, height,
thickness and weight of your material
• Position the printheads
These setup adjustments determine how reliably your printer
feeds. To set the printer properly follow the steps in this
chapter.
1. Be sure your media falls within the specifications listed in
Chapter 2 of this guide.
2. Release the separator locking lever located on the left
side of the feeder as shown below.
Push down to unlock