Primera Technology BRAVOPRO XI 032910-511262 - Manual (Page 51)

Creating Discs 47
Intensity
The Intensity setting will control the amount of ink
saturation on the disc. When printing onto the Primera
TuffCoat discs, 96% is usually sufficient. When printing
on to other brands of media, or if you would like to print
darker colors, you may wish to increase the Intensity
setting.
Inner Diameter
The inner diameter refers to the size of the non-printed
center on your disc. The size of the center hub can vary
from one type of media to the next. This allows you to set
the inner diameter in millimeters allowing you to print all
the way to the center hub regardless of the type of disc you
are using. For the discs that Primera sells, use the following
guide for Inner Diameter:
− 23 mm for Primera's Tuff-Coat media
− 24.9 mm for the Hockey Rink Disc, Business
Card Disc and 80mm CD
Outer Margin
The Outer Margin refers to where the printing will cut
off around the outer edge of your disc. The size of the
printable surface can vary from one type of media to the
next. This allows you to set the outer margin in millimeters
allowing you to print all the way to the edge regardless of
the type of disc you are using. The outer margin for
Primera's TuffCoat Media should be set to 0.7mm.
Save As Default
The Save As Default button will save the current settings
as the system-wide defaults.
Restore Defaults
The Restore Defaults button will restore the driver settings
to the factory defaults.
Config Utility
This button launches the Configuration Utility. This Utility
is also available browsing to Hard Drive - Library -
Printers - Primera - DiscPublisherProXi -
DiscPublisherProXiconfig. This utility is used to report ink
levels, clean and change ink cartridges, and align your
511262.qxd 10/15/2009 10:37 AM Page 47
TOC INDEX