Primera Technology BRAVOPRO XI 032910-511262 - Manual (Page 20)

16 Hardware and Software Setup
D. SETUP THE KIOSK BIN
Kiosk Mode allows you to use both of Publisher's Bins as
input, doubling your disc capacity from 50 discs to 100 discs.
In this mode, the finished discs will be deposited out through
the front " reject area " of the Publisher. In Kiosk mode all discs
would be ejected in this manner. Rejects can be identified in the
stack because they will not be printed in the same manner as
successfully recorded discs. Refer to the Kiosk Kit installation
instructions below.
• Attach the Output Bin
Holder as shown, aligning
the Locating Tabs on the
Output Bin Holder with
the Slots located on the
underside of the Publisher
allowing the holder to
hang off the edge of the
table. Notice the slots do
allow for adjusting the
position of the output bin.
If your discs are not
falling into the bin, you
will be able to move the
bin slightly to align it.
• Place the Output Bin on
the Output Bin Holder as
shown.
To enable Kiosk Mode, Open
PTPublisher - select Options from
the Tools menu - find the Options
tab - now check the Kiosk Mode
box. On a Mac, Kiosk Mode can be
enabled in the the Robot Options
menu.
Slots
Locating Tabs
511262.qxd 10/15/2009 10:35 AM Page 16
TOC INDEX