Pentax Browser 2.0 - Manual (Page 20)

18
J is used as an example here. When using w, [Transfer
Mode] does not need to be set. Go to “Connecting the Camera and
Macintosh” (p.19).
1
Press the 3 button on the camera.
The [A Rec. Mode] menu or the [Q Playback] menu appears.
2
Press the four-way controller (5) to display the [H Set-up]
menu.
3
Use the four-way controller (23) to select [Transfer Mode].
4
Press the four-way controller (5).
A pull-down menu appears.
5
Use the four-way controller
(23) to select [PC].
6
Press the 4 button on the camera.
Saving Images by Connecting Your Camera
and Macintosh (For Macintosh)
Setting the USB Connection Mode to [PC]
• Do not connect the camera to your computer while [PictBridge] is selected for
the [Transfer Mode].
• If the USB transmission speed of the computer is slower than that of the
camera, an error may occur when transferring data. If this occurs, set the
Transfer Mode to [PC-F]. This sets the transfer speed to the USB 1.1 data
transfer rate, thereby reducing the possibility of an error.
NTSC
P C
P C - F
Brightness Level
Set-up
Video Out
Transfer Mode
Auto Power Off
File #
Sensor Cleaning
0
OK OK Cancel
PictBridge