Philips SD AG-HPX171E - Manual (Page 126)

E-16
Appendix
When a P2 card with a memory capacity of 8
GB or more is used in this unit and a one-time
continuous recording exceeds the prescribed
duration (approx. 5 minutes for DVCPRO HD,
approx. 10 minutes for DVCPRO50 or approx.
20 minutes for DVCPRO or DV) or when a one-
time recording extends over more than one P2
card, the recording concerned will automatically
be undertaken as a separate clip.
At this time, each clip will be provided with its
own COUNT value.
Example of recording (DVCPRO50) a clip on one P2 card:
REC start
(recording start)
REC/PAUSE
(recording pause)
Recording duration = Approx. 15 min.
Clip 1
COUNT value = 0001
Clip 2
COUNT value = 0002
10 min. 5 min.
Example of recording a clip on two P2 cards:
REC start
(recording start)
REC/PAUSE
(recording pause)
Clip 1
COUNT value = 0003
Clip 2
COUNT value = 0004
1st card 2nd card
If the clip thumbnails are displayed as shown in the
example above or their properties are indicated
using a P2 device, the thumbnail and COUNT
value of clip 1 will be displayed.
Selecting the USER CLIP NAME
recording method
Press the MENU button and select META DATA
"
PROPERTY " USER CLIP NAMEto select
the recording method. Two options are available:
TYPE1and TYPE2.

TYPE1
USER CLIP NAME to
be recorded
If clip metadata has
been read in
Uploaded data
If no clip metadata
has been read in
or if the setting
for recording clip
metadata has been
turned off
Same as GLOBAL
CLIP ID (UMID data)
 TYPE2
USER CLIP NAME to
be recorded
If clip metadata has
been read in Uploaded data +
COUNT value*
If no clip metadata
has been read in
or if the setting
for recording clip
metadata has been
turned off
Same as CLIP NAME
* The COUNT value is indicated as a four-digit
number.
The COUNT value is incremented each time a
new clip is captured if clip metadata has been
read in and TYPE2 has been selected as the
recording method.
The COUNT value can be reset using the
following procedure.
Press the MENU button and select META DATA
"
PROPERTY " USER CLIP NAME to display
the menu shown below. Select “COUNT RESET”
with the cursor and press the Operation lever to
reset the COUNT value to 1.