Philips SD AG-HPX171E - Manual (Page 108)

E-108
Item
Display
mode
Description of settings
TIME STAMP (Camera) Determines whether or not date and time information will be
superimposed on the image.
ON: Superimposes date and time information on the image.
OFF: Does not superimpose date and time information on the image.
When DATE/TIME on the DISPLAY SETUP screen is set to OFF, the
date and time information is not superimposed.
PLAYBACK FUNCTIONS screen
Item
Display
mode
Description of settings
AUDIO OUT (MCR) Sets the audio signals to output from the AUDIO OUT pin jack when
the P2 card or the tape is played back.
CH1 · CH:
CH1 output = CH1 signals, CH2 output = CH2 signals
CH1:
CH1 output = CH1 signals, CH2 output = CH1 signals
CH:
CH1 output = CH2 signals, CH2 output = CH2 signals
CH3 · CH:
CH1 output = CH3 signals, CH2 output = CH4 signals
CH3:
CH1 output = CH3 signals, CH2 output = CH3 signals
CH:
CH1 output = CH4 signals, CH2 output = CH4 signals
AV IN/OUT SETUP screen
Item
Display
mode
Description of settings
CMPNT/SDI SEL (Camera)
(MCR)
Selects the type of component terminal or SDI connector.
When SYSTEM FREQ is set to 50 Hz:
AUTO: Monitor with D4 terminal (720P/1080i/576i output)
1080i: Monitor with D3 terminal (1080i/576i output)
576i: Monitor with D1 terminal (576i output)
When SYSTEM FREQ is set to 59.9 Hz:
AUTO: Monitor with D4 terminal (720P/1080i/480i output)
1080i: Monitor with D3 terminal (1080i/480i output)
80i: Monitor with D1 terminal (480i output)
Only video recorded at 720P is cross-converted to 1080i. Cross-
conversion does not take place in other cases.
SDI OUT (Camera)
(MCR)
Selects video output from component terminal or SDI OUT terminal.
ON: Video is not output via the component terminal but from the SDI
connector.
OFF: Video is output via the component terminal but not from the SDI
connector.
SDI METADATA (Camera)
(MCR)
Determines whether or not metadata is superimposed on SDI signals
during HD-SDI output.
ON: Superimposes metadata.
OFF: Does not superimpose metadata.
SDI EDH (Camera)
(MCR)
Determines whether or not EDH is superimposed on SD-SDI signals
during SD-SDI output.
ON: Superimposes EDH.
OFF: Does not superimpose EDH.
___indicates the factory setting.
Setup menu list (continued)
RECORDING SETUP screen (continued)