Polycom V2IU Converged Network Appliance 6400-S - Manual (Page 52)

User Guide V 2 IU 6400-S Converged Network Appliance
7 - 6
Press Submit.
Restarting the network
Use Network Restart to stop and the restart all the networking services that are
running on the system. Technical support may request that networking
services be restarted during a troubleshooting session.
Restarting network services will interrupt the system for up to a minute. All
voice and data sessions currently in progress will be interrupted! Proceed with
caution!
To restart the network:
1. In the navigation bar, select System.
2. In the System menu, select Network Restart.
3. In the Network Restart page, press Restart.
Rebooting the system
Rebooting the system stops all networking services and reboots the 6400-S.
The operating system and networking services will be loaded from scratch.
Reboot is functionally equivalent to power cycling the 6400-S. Technical
support may request that the system be rebooted during a troubleshooting
session.
Rebooting the system will interrupt services for a few minutes. All voice and
data sessions currently in progress will be interrupted! Proceed with caution!
To reboot the system:
1. In the navigation bar, select System.
2. In the System menu, select Reboot system.
3. In the Reboot system page, press Reboot.
Using Network Test Tools
A network administrator may use the test tools on this page to verify
connectivity of the 6400-S and trace the path of data throughout the network.
You can run a ping test or a traceroute test.