Input channel controls, Input channel controls –18 – Polycom C16 User Manual
Page 98
Design Guide for the Polycom SoundStructure C16, C12, C8, and SR12
5 - 18
Input Channel Controls
This section discusses the input controls in the order that they appear on the
channels page. The input channel settings are shown in the following figure in
both a collapsed view and with the different areas expanded to show the addi-
tional controls.
Any setting for a virtual channel can also be set by adjusting the setting on a
virtual channel group. By using virtual channel groups, the system can be
setup very quickly because the parameters will propagate to all the underlying
virtual channels.
The input channel controls may be expanded to show less frequently used con-
trols such as phantom power, trim, delay compensation, and the selection of
the different ungated signal types. See Chapter 2 for more information about
the ungated/recording signal types and the signal processing that is available
on those signal paths. More frequently used controls such as input gain and
input fader are always available and are visible even when the control is