Description, Sig_gen_sweep_time signal generator sweep time – Polycom C16 User Manual

Page 438

Design Guide for the Polycom SoundStructure C16, C12, C8, and SR12

A - 96

sig_gen_sweep_stop Signal Generator Sweep Stop Frequency

Description

When the signal generator’s sig_gen_type is set to sweep, the parameter sets the

frequency (in Hz) at which the sweep generator stops. The direction of the

frequency sweep will be up or down depending on whether the

sig_gen_sweep_start parameter is higher or lower than this parameter.

sig_gen_sweep_time Signal Generator Sweep Time

Description

When the signal generator’s sig_gen_type is set to sweep, this parameter sets

the duration (in milliseconds) that the sweep generator takes to sweep from its

start frequency to its stop frequency.

Argument

Argument value

Channel Type

Virtual Channel

Value Type

Floating-Point

Read/Write Mode

Read/Write

Phys Chans

Signal Generator

Virt Chans

Mono

System Limits

Minimum: 20.0, Maximum: 20000.0, Resolution: 0.1

Default

20000.0

User Limits
Supported