beautypg.com

Troubleshooting – Philips DVDR7310H User Manual

Page 90

background image

English

90

Troubleshooting

(continued)

Problem

(HDMI)

Solution

No audio output from HDMI
connection.

No video output from HDMI
connection.

EPG (GUIDE Plus+) data is
not available.

– You will not hear any sound from the HDMI output if the

source device is only DVI/HDCP (High-bandwidth Digital
Content Protection)-compatible.

– It is not possible to output SACD or copy-controlled DVD-

Audio sources from the HDMI connection.

– When the HDMI on this recorder is used to connect to a TV, it

can be no digital audio/surround sound on Coaxial/Optical
output, depending on the TV’s audio capabilities. Press SETUP
on the remote control, go to Audio Output setting and set the
HDMI to { Disable }.

– Make sure that you have activated this recorder as the HDMI

input in the settings for the device you are using. See HDMI
setting.

– HDMI connection can only be made to HDMI-equipped devices

with HDCP (High Bandwidth Digital Content Protection). If you
wish to connect to a DVI connector (equipped with HDCP), you
will need a separate adaptor (DVI to HDMI).

– Make sure the resolution of this recorder matches the device

you have connected using the HDMI. See HDMI setting.

– Check if the HDMI cable is faulty. If there is not signal received

from the HDMI connection, the { Video Upscaling } and { HDMI
output } options in the system menu video output settings will
be greyed out. Replace a new HDMI cable.

– When connecting to a non-HDCP compliant TV, the HDCP

warning message will appear only on the analogue video output.

– When the HDMI and component video are used to connect to a

TV at the same time, it can be no picture output from the
component video connection. Disconnect the HDMI cable.

– Turn off the recorder to standby mode for at least 24 hours. It

will enable downloading of TV listings data. If the recorder is
connected to a cable box/satellite receiver, make sure that it is
switched to the host channel during that 24 hours.

– Make sure that no timer recording is programmed during this

timing, as it will interrupt the EPG downloading.