Panasonic WJ-NT104 - Manual (Page 24)

24
2. Windows98 Setup
If the Dial-Up Networking icon is not in My Computer , it is not installed. You can use the following procedure to install it.
(1) Click the Start button, point to Settings , and then click Control Panel .
(2) Double-click Add/Remove Programs .
(3) Click the Windows Setup tab, click Communications , and then click the [Details] button.
(4) Click the Dial-Up Networking check box, and then click the [OK] button.
Click OK again, and follow the instructions on your screen.
w If more than one modem is connected, click the tab at the top of the box and select a modem to use.
e Check Allow caller access .
r Click the [Change Password...] button.
The Dial-Up Networking Password dialog box is displayed.
t Enter a password, and then click the [OK] button
Type the same password as used to set up the connection and modem/TA.
y Click the [Server Types...] button to display the Server Types dialog box.
u For Types of Dial-Up Servers , select PPP:Internet, Windows NT Server, Windows98 .
i In the Advanced options field, remove checks from Enable software compression and Require encrypted password .
o Click the [OK] button.
The screen returns to the Dial-Up Server dialog box. Click the [OK] button.
q Click the icon on the taskbar to display the Dial-Up Server dialog box.