Printronix T5000e Series - Manual (Page 70)

Chapter 2 Troubleshooting
70
The printed labels look clean, but
the validator is still reporting an
error message. The validator glass may be dirty, distorting the
report results. Power down the printer and clean
the glass using a household glass cleaner and a
dry, lint-free cloth.
The printed bar codes are
causing error conditions. There are a number of factors which could be
causing validation errors:
• The scanning beam is not properly aligned
with the two notches on the tear bar of the
printer. See “Adjust The Scanning Beam” on
page 28.
• Make sure the entire bar code passes
completely under the scanning beam.
• The validator and printer are not properly
communicating. Test the validator operation
without using a host. See “Bar Code
Validation Demo Page” on page 36.
• Bar code width. The validator can recognize
x-dimensions as narrow as 6.6 mil for
300 dpi printers, and 10 mil for 203 dpi
printers. The validator cannot recognize
x-dimensions smaller than 6.6 mil or larger
than 40 mil.
• Bar code size. A minimum height of 1/8 inch
is required for validation.
• Bar code type. The validator only
recognizes the following linear, picket fence
bar codes: Codabar, Code 39, Code 93,
Code 128, Interleaved 2 of 5, and UPC/EAN
+ add-ons. Stacked, 2D, and vertical
(ladder) bar codes are not supported.
Table 5. Troubleshooting the Validator
Symptom Solution