Printronix T5000e Series - Manual (Page 32)

Chapter 1 Adjust The Scanning Beam
32
Summary Of Scanning Beam Adjustment
NOTE: If the printer does not have a tear bar with notches at the
ends, adjust the scanning beam so that the center of the
beam is approximately 0.06 inches (1.52 mm) from the
lower edge as shown in Figure 16.
Figure 16. Adjusting the Center of the Scanning Beam
To Move Beam
Down
To Move Beam
Up
To Rotate Beam
Clockwise
To Rotate Beam
Counterclockwise
Tighten top left
screw Tighten both bottom
screws Loosen bottom
right screw Loosen bottom left
screw
or or or or
Loosen both
bottom screws Loosen top left screw Tighten bottom
left screw Tighten bottom
right screw
0.06 inches
(1.52 mm)