Validator statistics – Printronix T5000e Series User Manual
Page 47

Validator Statistics
47
5.
Press + or – to cycle through the choices:
•
Short Report. Default setting. Provides the encoded
failure cause or pass indication and the bar width deviation,
shown as a percentage.
•
Full Report. Provides a completed report of all the data
captured by the validator.
•
Validation Mode. Provides the same data as the Short
Report, but adds the actual bar code data read.
6.
When your selection displays, press
↵ to activate it.
7.
Press
↓ and ↵ at the same time to lock the ↵ key, then press
PAUSE to take the printer offline.
8.
Press PAUSE again to put the printer online.
Validator Statistics
The validator displays a number of statistics directly on the printer
LCD, without having to print a report. To view any of the statistics:
1.
Press
to take the printer offline and place the printer in
Menu mode.
2.
If necessary, press
↓ and ↵ at the same time to unlock the
↵ key.
3.
If necessary, press
until “VALIDATOR” displays.
4.
Press
↓ to scroll through the following statistics on the printer
display:
•
Good Barcodes: The number of bar code reports sent
from the validator since the last Clear Data command.
•
Good Forms: The number of forms printed since the last
Clear Data command.
•
Overstrike Forms: The number of forms containing a bar
code that fell below the minimum acceptable level since the
last Clear Data command.
•
Average BWD: The average of all Bar Width Deviations
reported since the last Clear Data command, shown as a
percentage.
..
.
..
.