Printronix T5000e Series - Manual (Page 18)

Chapter 1 Installation
18
Figure 4. Wrapping the Power/Data Cable Around the Ferrite
4. Using the end of the power/data cable with the short connector,
insert the cable through the ferrite. (Figure 4.)
5. Wrap the power/data cable around the ferrite twice.
6. Adjust the position of the ferrite so that the length from the
ferrite to the long connector is 20 ± 0.5 in
ches .
Power/Data Cable
Second Wrap
Short Connector
(To Controller Board)
Power/Data Cable
First Wrap
Ferrite
Long Connector
(To Validator)
20.0 ± 0.5
inches