Panasonic KX-P8410 - Manual (Page 137)

Error writing to
KXP8410GDI: for <
print job
name >: The printer command
is invalid. Do you wish to
retry or cancel the job?
137
Care and Maintenance
Error message Possible cause Recovery
Can not initialize ASPI for
Windows. Install newer
version of ASPI for
Windows. SCSI Board and its
driver are not installed
correctly. Correctly install SCSI board
and its driver. (Refer to the
instructions manual of the
SCSI board.)
Wnaspi32.dll will be
installed or replaced with a
new version.
For any other trouble related
to SCSI, refer to the SCSI
section of Care and
Maintenance
( ☞ P. 127) .
ASPI Manager is not
found. Install ASPI for
Windows. (e.g. install
wnaspi32.dll to your
system32 directory). SCSI Board and its
driver are not installed
correctly. Correctly install SCSI board
and its driver. (Refer to the
instructions manual of the
SCSI board.)
Wnaspi32.dll will be
installed or replaced with a
new version.
The ASPI for Windows
installed on this PC does
not have expected
function. Install newer
version of ASPI for
Windows.
The ASPI for Windows
installed on this PC does
not support expected
mode. Install newer
version of ASPI for
Windows.
The ASPI for Windows
installed on this PC does
not support Windows.
Install ASPI for Windows.
[e.g.install wnaspi32.dll to
your system32 directory]
Printer Driver For Windows NT 4.0
Separator page has
been set. When SCSI
port is used, Separator
page cannot be used. Cancel the Separator page
setting.
Error writing to LPT1: for
“Application name”: The
device is not ready. Do
you wish to retry or
cancel the job? Connect the printer (parallel
cable) correctly or make the
printer ready. Cable connection is
improper or printer is not
ready.