Paxar 656 / 636 - Manual (Page 31)

Users Manual Model 656/636 Control Panel Operation • 25
Use the Mode ↓ key to move to the following screen.
CHANGE THE CUT
CUT: 0 NEW CUT: -2
Each increment for 300 dpi machine = .026"
Each increment for 240 dpi machine = .025"
Use the NO key to increase
the number.
Adjustment from - 9 to + 10. Zero is the middle of the range
Use the Enter ↵ key to save the new value
CUTTER IS DISABLED
PRESS ENTER TO ENABLE
This screen allows the operator to turn the cutter ON or OFF.
Press the Enter ↵ key, this will toggle between the enable / disable mode.
The screen will display the cutter status on the first line.
The knife motor will continue to run. If the printer is used in the rewind
mode only, the knife motor plug may be disconnected.
CHANGE STROBE
STROBE: 0 NEW STROBE: +2
0 = Recommended center position, adjustable to ± 7 settings.
Use the NO key to increase
the number.
Use the Enter ↵ key to save the value and move to the next number.
Recommend cleaning the head, adjusting head tangent and setting head
pressure before changing this strobe setting.
EMULATION MODE:630
NEW EMULATION MODE:650
This screen follows the STROBE ADJUST screen. This screen allows the
selection of an emulation mode. The 656 / 636 is capable of emulating
other PAXAR printers. When in this mode, the 656 / 636 will produce PCL
tags as close as possible to the tags produced by the printer being emulated.
Formats designed for the 656 / 636 can not be printed on the older printers,
but formats designed for the older printers emulated by the 656 / 636 can be
printed on the 656 / 636 printer.
Compatibility Notes:
• If the dpi of the 656 / 636 printer does not match the emulating printers
dpi, then certain field types such as barcodes, logos, care symbols will
not be the exact size of the fields printed on the older printer.