Panasonic PT-DW8300U - Manual (Page 85)

PROJECTOR SETUP menu
ENGLISH -
85
Settings
Press button. 4 )
The [ADJUST CLOCK] screen will be displayed. z
Press ▲▼ to select the item to be set, 5 )
and press ◄► to set the local time.
Press ▲▼ to select [APPLY], and
6 )
press button.
This completes setting of the time. z
J Adjusting the date and time
automatically
Press ▲▼ to select [DATE AND TIME]. 1 )
Press button. 2 )
Press ▲▼ to select [ADJUST CLOCK]. 3 )
Press button. 4 )
The [ADJUST CLOCK] screen will be displayed. z
Press ▲▼ to select [NTP 5 )
SYNCHRONIZATION] and press ◄► to
switch to [ON].
The setting will change as follows each time z
◄► is pressed.
OFF ON
Press ▲▼ to select [APPLY], and 6 )
press button.
This completes setting of the time. z
Note
To set the date and time automatically, the projector must z
be connected to the network.
If synchronization with the NTP server fails just after z
[NTP SYNCHRONIZATION] is turned [ON], or if [NTP
SYNCHRONIZATION] is turned [ON] while the NTP
server is not set, [NTP SYNCHRONIZATION] will return
to [OFF].
Access the projector via a web browser to set the NTP z
server. ( Æ page 106)
LENS CALIBRATION
This automatically sets the limit value of the lens shift
and the home position of the projector.
Press ▲▼ to select [LENS 1 )
CALIBRATION].
Press button.
2 )
A confirmation message will be displayed. z
Press ◄► to select [OK], and press 3 )
button.
To stop, select [CANCEL]. z
The lens will move vertically and horizontally, z
and the limit value of the lens shift and home
position are set automatically.
The lens will stop, completing the calibration. z
Note
While lens calibration is being executed, a message z
[PROGRESS] appears on the menu. The calibration
cannot be canceled halfway.
If the lens calibration has been correctly executed, a z
message [COMPLETE] will appear. If the calibration has
not been correctly executed, a message [INCOMPLETE]
will appear.
FILTER COUNTER RESET
After you replaced the Auto Cleaning Filter (ACF),
[REMAINING FILTER] of [STATUS] need to be reset
to [0].
Press ▲▼ to select [FILTER COUNTER 1 )
RESET].
Press button.
2 )
The [RESET FILTER COUNTER?] screen will z
be displayed.
Press ◄► to select [OK], and press 3 )
button.
Note
For replacing ACF unit, refer to z “
■
Procedure of ACF unit
replacement” ( Æ page 109).
If the filter has not been installed, [OK] cannot be z
selected.
The filter is wound during the resetting operation. Some z
sound may be produced during the winding operation.