Panasonic PT-DW8300U - Manual (Page 65)

ADVANCED MENU
ENGLISH -
65
Settings
J
To display the adjustment marker
Press ▲▼ to select [MARKER]. 7 )
Press ◄► to select [ON]. 8 )
A marker for adjusting the overlap position z
appears. The optimal point is the position where
the red line of one frame overlaps the green
line of the other frame.
The blending widths of each projector must be
set to the same value. Optimal blending cannot
be achieved if the widths are different.
Press ▲▼ to select [BRIGHT 9)
ADJUST].
Press button.
10)
The [BRIGHT ADJUST] screen will be z
displayed.
Press ▲▼ to select [BRIGHT INSIDE]. 11)
Press button. 12)
The [BRIGHT INSIDE] individual adjustment z
screen will be displayed.
When [INTERLOCKED] is set to [OFF], z
individual adjustment of [RED], [GREEN] and
[BLUE] will be possible.
Press ▲▼ to select an item, and 13)
press ◄► to adjust the setting.
Once adjustment is complete, press z
button to return to [BRIGHT ADJUST] screen.
Press ▲▼ to select the part of 14)
[UPPER], [LOWER], [RIGHT], [LEFT].
Press ◄► to adjust the width for
15)
correcting the [BRIGHT INSIDE]
setting (0 to 255).
Press ▲▼ to select [BRIGHT
16)
OUTSIDE].
Press button. 17)
The [BRIGHT OUTSIDE] individual adjustment z
screen will be displayed.
When [INTERLOCKED] is set to [OFF], z
individual adjustment of [RED], [GREEN] and
[BLUE] will be possible.
Press ▲▼ to select an item, and 18)
press ◄► to adjust the setting.
Note
The [BRIGHT INSIDE] adjustments are used to match z
the projector’s main-screen-area black levels to the level
within the blended area.
The [BRIGHT OUTSIDE] adjustments may be used to
fine adjust the thin borders on either side of the blend
area, but are often not needed.
When a rear screen or screen with a high gain is used, z
the blended areas may appear to be discontinuous
depending on the viewing position.
When using both horizontal and vertical edge blending z
functions to form a multiple projector image, adjust the
[BRIGHT BLENDING] before performing the adjustment
in Step 11).
When using only one of the horizontal or vertical edge z
blending functions, set all items of [BRIGHT BLENDING]
to [0].
Red line
Green line
The optimal point is where these lines overlap.
BRIGHT
BLENDING
MAKER
BRIGHT OUTSIDE
Edge blending width (right)
BRIGHT adjustment (right)
BRIGHT INSIDE
Projection range