beautypg.com

Precautions, 1 interference during exercise – POLAR F55 User Manual

Page 88

background image

90

ENGLISH

10.1 INTERFERENCE DURING EXERCISE

Electromagnetic Interference

Disturbances may occur near high voltage power lines, traffic lights,

overhead lines of electric railways, electric bus lines or trams,

televisions, car motors, bike computers, some motor driven exercise

equipment, cellular phones, or when you walk through electric

security gates.

Exercise Equipment

Several pieces of exercise equipment with electronic or electrical

components such as LED displays, motors, and electrical brakes

may cause interfering stray signals. To try to tackle these problems,

relocate the wrist unit as follows:

1. Remove the transmitter from your chest and use the exercise

equipment as you would normally.

2. Move the wrist unit around until you find an area in which it

displays no stray reading or does not flash the heart symbol.

Interference is often worst right in front of the display panel of

the equipment, while the left or right side of the display is

relatively free of disturbance.

3. Put the transmitter back on your chest and keep the wrist unit in

this interference-free area as far as it is possible.

4. If the Polar heart rate monitor still does not work with the

exercise equipment, this piece of equipment may be electrically

too noisy for wireless heart rate measurement.

Crosstalk

When in non-coded mode

the wrist unit picks up transmitter

signals within 3 feet/1 meter. Simultaneous non-coded signals from

more than one transmitter can cause an incorrect readout.

Using the Polar Heart Rate Monitor in a Water Environment

Your Polar heart rate monitor is water resistant and can be used

when swimming. The fitness heart rate monitor is not, however, a

diving instrument. To maintain the water resistance, do not press

the buttons of the wrist unit under water.

Users measuring their heart rate in water may experience

interference for the following reasons:

• Pool water with a high chlorine content and seawater are very

conductive. The electrodes of a transmitter may short-circuit,

which prevents ECG signals from being detected by the

transmitter.

• Jumping into water or strenuous muscle movement during

competitive swimming may cause water resistance that shifts

the transmitter on the body to a location where it is not possible

to pick up ECG signals.

• The ECG signal strength depends on the individual and also

varies depending on an individual’s tissue composition.

The percentage of people who have problems in heart rate

measuring is considerably higher in water than in other use.

10. PRECAUTIONS