Philips V30 - Manual (Page 25)

X
Go to cover page
25 107T5
DDC Instructions
Fig. 20
Fig. 22
Fig. 23
Fig. 21
Step 10: Exit DDC program
Pull down the File menu and select Exit as shown in Fig. 21.
(EDID Tool 3.01)
Step 9: Load DDC data
Open
1. Click from the tool bar.
2. Select the file you want to open as shown in Fig. 20.
3. Click .
4. Access "Factory Mode" and enable "Software DDC only" as shown
in Fig. 17 & Fig. 16.
5. Write EDID (click ).
Note1 : In User Mode: Read DDC data only
Software
DDC only was disabled
Before read EDID code, please confirm that the
as shown in Fig. 22.
Note 2 : In Factory Mode: Read/Write DDC data
Software DDC only was enabled
Before Read/Write EDID code, please confirm that the
as shown in Fig. 23.
If you do not disable "Software DDC only", when you execute
"read EDID", it will bring up an error message as below.