Printronix Integrated Network Interface Card - Manual (Page 254)

Chapter 12 Complete Command List
250
< len-type> indicates the selected preamble length ("long", "short"or
"default").
< sleep-time> indicates the power-save sleep-time in milliseconds.
If power-save is disabled (time is set to zero), "normal (power-save
off)" displayd.
< key-num> is the number identifying one of the four encryption
keys, starting from one. Encryption is disabled if "Encryption
disabled" displayd.
is the authentication method e.g. open, shared,
kerb, leap.
is the authentication method user name.
is the authentication method password.
< power> is a percentage indicating the approximate fraction of full
power.
< option-list> is a list of options that are enabled (disabled options
are not shown).
< profile> is the 802.11g/b wireless mode in use.
is the WPA wireless mode selected.
is the selected WPa cipher setting.
is the WPA passphrase represented as *
characters if configured.
is the currently configured country setting that is
used to determine valid channel settings with which the 802.11g
wireless NIC is used to communicate with an access point.
< status> is the current access point association status
(“disassociated” or “associated with ”)
< comms-quality> indicates the strength or quality (in percent) of the
wireless signal.
NOTE: The "list stored ifc" command does not display the "Status"
or "Quality" lines.
list kerberos
For Wireless NIC with Symbol RF cards only.