Printronix Integrated Network Interface Card User Manual
Page 231
Store Commands
227
store pserver name
Example: store pserver name NIC1234
Command to change the print server name.
store pserver opts [[-]jobsecurity]
[jobtimeout
enhanced]]
Example: store pserver opts [-]jobcontrol
If jobcontrol is disabled then the need for start of job / end of
job flow control with the printer is determined by the printer. Job
flow control is used for jobs requiring backchannel responses
such as IPDS, TN5250 and PJL jobs only. This is available as
a performance enhancement for LPR, TCP socket printing etc.
The job flow control has no affect on IPDS, TN5250, and PJL
jobs. These options perform their own control. When jobcontrol
is enabled all jobs will be supported with job flow control.
NOTE: When jobcontrol is disabled, dynamic config loading on a
model change is also disabled.
•
off. no job control; no SOJ/EOJ commands. The printer prints
faster in off mode.
•
standard. (the default) traditional job control with immediate
acknowledgements of SOJ/EOJ commands.
•
enhanced. job control with EOJ acknowledgements held off by
the printer until job is fully printed. The printer prints slower in
enhanced mode.
To monitor the printer, use the telnet command “lpstat.” The normal
status reported on the first line of the lpstat response is the status of
the queue (LPQ) within the NIC. The status reported does not
reflect the state of the print job once it has been sent from the NIC
to the printer.