Printronix Integrated Network Interface Card - Manual (Page 248)

Chapter 12 Complete Command List
244
“-all” disables and “all” enables reporting of alerts in all alert
groups. Individual alert groups can be selectively enabled or
disabled via combinations of alert group switches. For
example, to enable warning alerts and disable cutter alerts for
SNMP table entry 1, enter the following:
set snmp alerts 1 warning -cutter
set snmp syslog [-]active
The NIC can also log SNMP alert messages to the defined
SYSLOG host (see the ‘set sysinfo syslog’ command
description). Use this command to enable or disable logging of
alert messages for an SNMP alert table entry.
is the index number of the SNMP alert table. “active”
enables alert message logging, “-active” disables it.
set sysinfo label|name []
Example: set sysinfo name salesprinter
Set a descriptive name defined by for NIC
identification purposes. This is not used in the operation of the
print server in any way.
set sysinfo contact []
Example: set sysinfo contact Paul_Harris
Set a person or department to contact in case of print server
trouble.
set sysinfo location []
Example: set sysinfo location salesdept
Set the physical location of the NIC. This is for identification
purposes and is not used in the operation of the print server in
any way.
set sysinfo prnserial []
Example: set sysinfo prnserial 000123456789
Sets the printer serial number.