Printronix Integrated Network Interface Card - Manual (Page 171)

Configuring PSF/400 For IPDS On V3R2
167
d. Activate release timer (ACTRLSTMR)
Specifies the point at which the release timer (RLSTMR) is
activated. Set to *NORDYF. This means that the release
timer is activated when there are no spooled files in the
printer’s output queue with a status of RDY and the last
page of the last spooled file processed has printed.
*NORDYF is used so that all files with a status of RDY are
printed before releasing the session (which does not
terminate the writer, however).
e. Release timer (RLSTMR)
Specifies the amount of time to wait before a session or
dialog is released without terminating the writer. The
ACTRLSTMR parameter specifies when this timer is to be
activated. Set the parameter to a value at least equal to the
TIMEOUT value on the printer. The recommended value is
*SEC15 .
f. Remote Location name or address (RMTLOCNAME)
Enter the IP address or hostname of the printer.
g. TCP/IP port (PORT)
Specify 5001.
h. TCP/IP activation time (ACTTMR)
This value specifies the number of seconds that PSF/400
waits for a printer to respond to an activation request. If
only one system is using the printer, use the default value
(170 seconds). If more than one system is using the printer,
specify *NOMAX, which causes PSF/400 to wait indefinitely
for a response to an activation request.