Printronix Integrated Network Interface Card - Manual (Page 250)

Chapter 12 Complete Command List
246
set sysinfo syslog hostIPaddress
Example: set sysinfo syslog 192.75.11.30
Set the IP address of the host running the SYSLOG daemon.
NIC debugging or print job and printer logging information can
be sent to that IP address.
set sysinfo dns
Example: set sysinfo dns 192.75.11.2
Set your DNS server IP address so the NIC can resolve host
names when used with its built-in Telnet and ping clients.
set sysinfo domain
Example: set sysinfo domain printronix.com
Sets the domain name for the NIC, which when combined with
the print server name, forms the fully qualified domain name of
the NIC.
set sysinfo module [[-]novell] [[-]netbios]
Example: set sysinfo module -novell
Enable and disable certain network protocol stacks within the
NIC. Sometimes it helps to disable any protocols you are not
using on your network.
NOTE: [ - ] novell option is not available on the Integrated NIC.
set user add|del
Example: set user add eng
Add or remove a user on the NIC defined by .
IMPORTANT Do not delete the root user, or you will be unable to configure
any further settings on the print server. You will have to go
back to factory defaults to correct this problem.
set user passwd []
Example: set user passwd eng mplex1
Assign a password to a defined user on the NIC.
set user type root|guest
Example: set user type eng root
Assign root or guest privileges to a particular user defined by
username . Guest permissions allow viewing of settings only.
Root permissions allow complete control of the NIC.