Pitney Bowes PostPerfect B700 - Manual (Page 25)

3-2 SV60941 Rev. B
Turning the
Meter On Before You Apply Power
• Make sure the meter is plugged into a properly grounded
receptacle.
• If your're using an optional advertising slogan cartridge,
make sure it's in place (Chapter 8).
• Check that the stacker is in position (see instructions be-
low).
• Make sure the ribbon cassette is properly loaded (Chap-
ter 6).
• If you’re using a Pitney Bowes electronic scale with your
meter, make sure it’s connected properly. Follow the in-
structions supplied with the scale. (B700 only)
• Add E-Z Seal ® to the optional moistener if necessary.
Follow the instructions supplied with your moistener.
(B700 only)
The instructions that follow assume the meter is set up the
way you want. If not, go to Chapter 4 for step-by-step setup
instructions.
Applying Power
Insert the key and turn it
clockwise. After you turn it on,
the meter performs a self test
for several seconds and oper-
ates the envelope transport
mechanism.
If the self test is OK, the meter
shows the default postage
value in the operator display
as shown at the right (your de-
fault value may be different).
Warning Prompts
If postage funds are low, the operator display flashes “Low
Funds” or “Insuf Funds” alternately with the postage value
selected. If any other message appears on the display, see
pages 7-2 and 7-3 of this guide for an explanation.
HINT: If postage funds
are low, it's a good
idea to refi ll your me-
ter. See Chapter 5 for
instructions.
3 • Using the Meter