Palm Treo 300 - Manual (Page 16)

Section 1
8 Introduction to Your PCS Phone Handspring ® Treo™ 300
6. LED: Provides status information for your PCS Treo 300 based on the
color of the light and the blink state.
No light: Wireless mode off
Solid: Connected to travel charger
Green = Fully charged
Red = Charging
Blinking: Wireless mode on
Green = In coverage area
Red = Out of coverage area
Double-blink red: Low battery
Locating back panel components
1. Electronic Serial Number (ESN): Uniquely identifies your phone to
the PCS network. During the activation process, you are prompted to
provide this number.
2. Reset button: Under normal use, you should not have to use the
reset button. See Section 9 for information about when and how to
use the reset button.
3. Charger and USB/serial connector: The connector that connects
your phone to the travel charger and HotSync cable. The HotSync
cable connects to a USB port or serial port on your computer and
enables you to synchronize the information between your phone and
computer using HotSync technology.
2. Reset
button
3. Charger and
USB/serial
connector
1. Electronic
Serial
Number