Patton electronic 3088 Series - Manual (Page 20)

Introduction 20
Model 3088 Series User Manual 2 • Configuration
• If you attempt to modify any configuration parameters via the EOC (by changing (EOC variables), the
RocketLink-G will not execute your changes.
Table 2 lists the Model 3088’s configurable parameters.
Table 2. RocketLink-G configurable parameters
Parameter Description Possible Values
Password The password used to login to the console. Character strings 1–9
characters long.
Circuit ID The circuit ID used to identify the unit. Character string 1–64
characters long.
Front Panel
Switches If the device is populated with front panel switches, they can be
used to start and stop test modes. If they are disabled, however,
the front panel switch settings will be ignored. Enabled or Disabled
DTE Loops
(model C) The V.35 interface can request LALs and RDLs using its RRDL and
RLAL pins. If DTE loops are disabled, requests for loopbacks on
these pins will be ignored. Enabled or Disabled
TX Clock
(models C, A & D) Defines where (V.35 or X.21) serial transmit data is sampled in
relation to the TX clock: on the falling edge (normal) or the rising
edge (inverted) of the TX clock. Normal or Inverted
DSL Data Rate/
Timeslots Defines the number of DSL timeslots. The DSL data rate is calculated
by the equation: data rate = DSL timeslots x 64k. This value also
defines the maximum serial/T1/E1 data rate. 1–72
Serial/T1/E1
Timeslots Defines the total number of serial/T1/E1 timeslots utilized. This value
must be less than or equal to DSL timeslots. 1–72 (V.35)
1–72 (X.21)
1–24 (T1)
1–32 (E1)
Timeslot
Mapping
(models K & T) Defines T1/E1–to–DSL timeslot mapping. By default defined/utilized
DSL timeslots are mapped to the first n data–bearing timeslots on the
T1/E1 line. Line type determines which timeslots are data–bearing:
T1–Unframed: 1–24
a
T1–SF: 1–24 a
T1–ESF: 1–24 a
E1–Unframed: 0–31
E1–Fractional: 1–31
E1–CRC: 1–31
E1–MF: 1–15,17–31
E1–CRCMF: 1–15,17–31
Line Type
(models K & T) Defines the framing format of the T1 or E1 line. T1–Unframed a
T1–SF (D4) a
T1–ESF a
E1–Unframed
(Clear Channel
G.703)
E1–Fractional
E1–CRC
E1–Multiframe
E1–CRC & Multiframe