Patton electronic 3088 Series User Manual
User manual
RocketLink-G Model 3088 Series
G.SHDSL NTU with fixed
serial interface
User Manual
Sales Office:
+1 (301) 975-1000
Technical Support:
+1 (301) 975-1007
E-mail:
WWW:
www.patton.com
Part Number: 07M3088-GSG, Rev. J
Revised: February 15, 2012
Important
This is a Class A device and is not intended nor approved for use in a residential environment.
Start Installation
For Quick
Table of contents
Document Outline
- Summary Table of Contents
- Table of Contents
- List of Figures
- List of Tables
- About this guide
- Chapter 1 General information
- Chapter 2 Configuration
- Introduction
- Software (CLI) configuration
- Hardware (DIP-switch) configuration
- Configuring the DIP switches
- System reset mode
- DIP switch settings
- DIP switch settings for RocketLink-G models 3088/CA and 3088/D
- S1-1 through S1-7: Data Rate (RocketLink-G models 3088/CA and 3088/D)
- S1-8: TX Clock (RocketLink-G models 3088/CA and 3088/D)
- S2-2: Line Probe (Models 3088/CA and D)
- S2-3: Annex A/B (Models 3088/CA and D)
- S2-4 through S2-5: Clock Mode (Models 3088/CA and D)
- S2-6: DTE Loops (RocketLink-G models 3088/CA only)
- DIP switch settings for RocketLink-G models 3088/K and 3088/T
- S1-1 through S1-6: TimeSlots & Data Rate (RocketLink-G Models 3088/K and 3088/T)
- S1-7 and S1-8: Line Build Out (Models 3088/K and 3088/T)
- S2-2 Line Code (Models 3088/K and 3088/T)
- S2-3: Annex A/B (Models 3088/K and 3088/T)
- S2-4 through S2-5: Clock Mode (Models 3088/K and 3088/T))
- S2-6 through S2-8: Line Type (Models 3088/K and 3088/T)
- Console
- Remote Console
- RocketLink Plug ‘n’ Play
- Introduction
- Chapter 3 RocketLink-G installation
- Installation
- Connecting the twisted pair interface
- Connecting the Model 3088/CA (V.35) serial interface
- Connecting the Model 3088/D (X.21) serial interface
- Connecting the Model 3088/K serial interface
- Connect twisted pair (120 ohm) to E1 network
- Connecting dual coaxial cable (75 ohm) to E1 network
- Connecting the Model 3088/T (T1) serial interface
- Connecting power
- Installation
- Chapter 4 Operation
- Chapter 5 Remote console operation
- Chapter 6 Software Upgrade
- Chapter 7 Reset configuration to factory defaults
- Chapter 8 Contacting Patton for assistance
- Appendix A Compliance information
- Appendix B Specifications
- Appendix C Factory default values
- Appendix D Factory replacement parts and accessories
- Appendix E Interface pinouts