Powerware 9355 User Manual

Page 20

UPS SETUP

EATON Powerware

9355 Parallel UPS (10/15 kVA) User’s Guide

S 164201601 Rev A www.powerware.com

Repeat Steps 1 through 3 to remove the vertical bracket on the
other side.

Remove the front cover from the bottom cabinet to access the
front shipping bracket.

Press and release the handle latch at the bottom of the cover and
then lift the cover up and off the cabinet.

Remove the three M10 bolts securing the rear shipping pad to the
pallet and remove the shipping pad (see Figure 8).

NOTE Hold the back of the cabinet so that the bolts can be removed easily without the
cabinet rolling backward.

Remove the two M10 bolts securing the front shipping bracket and
remove the bracket.

If needed, adjust the leveling feet to release the bracket.

Front Shipping
Bracket

Shipping Pad

M10 Bolts

Figure 8. Removing the Front Shipping Bracket and Shipping Pad