Lexmark 2480 - Manual (Page 91)

87
Loading paper
Using the Tear Off bar
Setting the Tear Off position
When Auto Tear Off is On or set to One Second, it
moves the top perforation of a continuous form to the
Tear Off position when all of the following are true:
• The printer has finished printing.
• The paper has advanced to the Top-Of-Form
on the next page.
• No data, printer control codes, or escape
codes have been sent to the printer after
advancing to the Top-Of-Form.
• The print buffer has not received data for
one second.
If you have already set your Top-Of-Form and now want
to change the Tear Off bar position, follow these steps:
1 Press Start/Stop to take the printer offline.
2 Press and hold Tear Off until the printer beeps.
3 Open the operator panel cover to access layer 2.
4 Press Micro
↑
or Micro
↓
to move the paper to
the correct position on the Tear Off bar.
5 Close the operator panel cover.
The printer beeps twice.
The paper rolls backward, then goes to the new
Tear Off position.
6 The Ready light is On.
7 Press Start/Stop.
The paper remains at the current Tear Off position until
you send another job to the printer. The paper moves
from the Tear Off position to the Top-Of-Form and
begins printing.