Lexmark 2480 - Manual (Page 125)

121
Tr
oubleshooting
Setting printer to default settings
To reset the printer to the factory defaults:
Initialize printer to US defaults
The standard defaults for the United States are:
• Code page: 437
• Character Set: 1
• Form length: 11”
To change the defaults:
1 Make sure paper and the ribbon cartridge are
installed.
2 Turn the printer Off.
3 Open the ribbon access cover.
4 Move the printhead over toward the operator
panel side of the printer until it stops.
5 Close the ribbon access cover.
6 Press and hold Tear Off + Load/Unload while
you turn the printer On.
7 Continue holding these buttons until the carrier
moves.
Note: The operator panel lights blink On and
Off several times.
Once the carrier moves, your settings have been reset
to factory defaults.